Landing Light Switch - circa '53

4-Shipp · Post by **4-Shipp** » Thu Jul 04, 2002 4:11 am

Just finished a 2 1/2 day owner assisted annual - not too bad, learned a great deal, skinned a few knuckles, and reviewed the finer points of changing cylinders and setting zero lash gaps on pushrods, but that is another post...

I need a landing light switch. The plastic block inside mine has deformed over the years and allows the brass plate to ground against the case. Consequently whenever I turn on the second detent (landing) I blow the fuse. Are these switches availalbe or can parts be scrounged? Any help is as always appreciated.

Post by **GAHorn** » Thu Jul 04, 2002 10:04 pm

I've got one in good, used condition, Bruce. Where do I send it? George

4-Shipp · Post by **4-Shipp** » Mon Jul 08, 2002 10:25 pm

George, I sent a reply to your hotmail email address. Cheers.